|
Item
|
HI-TOO300D190A
|
|
Frequency
|
40KHZ
|
|
Input
|
220V/50Hz
|
|
Power
|
800W
|
|
Blade Width
|
190MM
|
|
Generator Dimension
|
400×180×280MM
|
|
Generator Weight
|
9KG
|
|
Transducer Type
|
Piezoelectric Ceramic
|
Ultrasonic cutting machine cutting equipment using ultrasonic energy, its greatest feature is cutting without edge. Or, without the traditional sense of the cutting edge. The conventional cut using a tool with a sharp edge, pressed against the material being cut. This stress is concentrated in the edge at the pressure is very large, and exceeds the shear strength of the material being cut, the molecules of the material to be opened, is severed. Since the material is strong pressure hard pull, the cutting tool edge should be very sharp, the material itself, but also to withstand the pressure. Of soft, flexible material cutting ineffective viscous material difficulties.
Ultrasonic cutting with a knife-edge is smooth, reliable, accurate trimming, no deformation, not while Alice, fluff, spinning, folds, etc..
Advantages and characteristics
1. High precision cutting, rubber unchanged
2. Easily applied to automated production
3. Cutting surface finish, good bonding properties
4. Speed, high efficiency, no pollution
5. Application of tire rubber parts: tread, nylon, sidewall, apex
Application
Application of ultrasonic rubber cutting parts:
Tread; nylon; nylon cord; lining; sidewall; triangular circle and so on.
The working principle of ultrasonic cutting
Ultrasonic cutting works by ultrasonic generator convert 50/60Hz current into 20,30 or 40kHz power. The converted high-frequency electrical
The working principle of ultrasonic cutting
Ultrasonic cutting works by ultrasonic generator convert 50/60Hz current into 20, 30 or 40kHz power. The converted high-frequency electrical energy is converted into an equivalent frequency of mechanical vibration by the transducer , followed by a set of mechanical vibration can transmitted to the cutter device via the changed amplitude of booster. Cutter will receive the vibration energy transferred to the cutting surface of the workpiece to be cut, in the region, the vibration energy is by activating the rubber molecules, the molecular chains to open the way for cutting the plastic material.
An ultrasonic cutting system's main components include ultrasonic generator, transducer / booster / cutter triple therapy group and a variety of cables.
